When driving on the road, the most common point of kimh is to pay attention to safety. Driving safety, one is the driver's safety habits, one is the safety configuration of the vehicle. Safety configuration, ranging from car body structure and safety system to tires and lamps, is very important. Today, kimh will tell you about the "headlight".

In fact, we have a lot of brick friends in the background who will ask us, for example, what should we do if our car is a "candle lamp" and we can't see it clearly at night. In fact, the lack of sight caused by lighting is indeed a major problem affecting safety. According to incomplete statistics, 22% of traffic accidents occur in poor visibility.


Generally speaking, for the sake of cost, most of the vehicles below 200000 are equipped with ordinary halogen bulbs. This is not a problem in daily use, but in some national roads and suburban rural areas where road lighting construction is not good, its lighting vision is not as good as the more advanced xenon and LED headlights.


This time, KIMH will teach you how to simply upgrade the lamp brightness and refuse "candle lamp"

Generally, the color temperature of ordinary halogen bulb is 3000K, the color is yellow, and the penetration is good. However, due to its simple structure, ordinary halogen bulb will not have high irradiation distance, angle and brightness, and even will fade and age after long use. Therefore, what we need to do is to directly buy LED bulbs with better performance.

After the bulb is ready, the next question is how to replace it? Upgrading LED headlights can be done by yourself. It takes about 20 minutes.

By the way, when purchasing light bulbs, be sure to see whether your car is integrated or separate. Don't mix it up, because the former only needs to change two special bulbs on the left and right, while the latter needs four.



Update led headlight:
First of all, open the hood and see what it looks like behind the headlight. This round black rubber ring is the dust and water-proof cover of the headlight. (some cars have a plastic cover outside the dust cover, which needs to be removed first.)


There is a headlamp power interface outside the dust cover. Gently pull it out first. If the pressure is tight, you can shake it left and right and pull it out slowly. Don't use brute force.


After pulling out the power interface, use a little force to take out the dust cover. It is usually made of soft rubber, so you don't have to worry about pulling it out.

Now, a naked headlight base has been shown in front of us.


But don't rush to pull out the bulb, because it can't be pulled out by hard pulling. There is a circle of clip spring made of iron wire outside the lamp holder. First loosen the clip spring, and then carefully take out the bulb.


The process of installing the lamp is very simple. Just turn it upside down according to the way of removal. Pay attention to remember to install the dust cover firmly.



Effect display：



So, just plug in disassembly, with no more difficult way than changing the light bulb at home, can be a good way to upgrade the car headlight. This is undoubtedly the most suitable choice for those who are worried about the trouble and trouble of refitting and the lack of light and safety of the headlights.

Since it's so easy to say goodbye to the candle?